Introduction to hydraulic woodworking cold press machine
Product Features In the refrigeration system of a refrigerated dryer, the evaporator is a device that delivers cold, and the refrigerant absorbs the heat of compressed air to achieve the purpose of dehydration and drying. The compressor is the heart, which plays a role in inhaling, compressing, and transporting refrigerant vapor. The condenser is a device that releases heat, transferring the heat absorbed in the evaporator along with the heat converted from the input power of the compressor to the cooling medium (such as water or air) for removal. The expansion valve/throttle valve plays a role in throttling and reducing the pressure of the refrigerant, while controlling and regulating the amount of refrigerant liquid flowing into the evaporator, and dividing the system into two parts: the high-pressure side and the low-pressure side.
Instructions for hydraulic woodworking cold press machine
(5) Set the holding time The duration of the holding time can be set according to actual needs: A: First, select the time mode: "hour h, minute M, second S". B: Then set the four numeric keys from 0 to 9 as needed: If the selected time mode is "hour h", the value set by the four numeric keys is "9999", At this point, the actual holding time is "99.99" hours, as set by the four numeric keys For "0003", the actual holding time at this time is "0.03 hours", as indicated by the four numeric keys The set value is "0905", and the holding time is "9.05 hours" (if set) If the time mode is "minute M" or "second S", the "hour" after its value will also change to Minutes or seconds. C: A large time value can be set to "99.99 hours". D: After the pressure holding timer is completed, the buzzer will sound to indicate that the workpiece has been pressurized. E: Prohibit setting the time to "0000".
Explanation of hydraulic woodworking cold press machine
Troubleshooting method: When the faults listed in the table below are detected, preliminary treatment can be carried out by referring to their solutions, If the fault cannot be eliminated yet, technical support from the manufacturer should be requested
