Introduction to plastering machine
Product Features:
The plastering machine is an automatic wall plastering machine, which mainly includes a lifting frame composed of front fixed column, front adjustment column, rear fixed column, rear adjustment column, main frame, hollow top column, pressure bar, etc. The transmission device consists of motor, governor, rope pulley, chain, steel wire rope, etc. The wall plastering device consists of mortar bracket, ash conveying board, plastering board, eccentric wheel, worm, gear, rack, etc. The automatic wall plastering machine is simple in structure, convenient and practical in operation, greatly reduces the movement intensity, saves time and labor, saves powder, and is suitable for wall plastering operations in the construction industry.
Instructions for plastering machine
Cleaning of wall plastering machine:
Cleaning and maintenance of a plastering machine is very important. Thorough cleaning and immediate maintenance will make your plastering machine look like new every day, and regular maintenance and cleaning will extend the service life of the plastering machine.
Cleaning method:
Key washing points: washing inside and outside the conveyor belt, vibrator, front and rear of the template, ash hopper, hydraulic casing, climbing wheel, caster wheel, and surface. 1. There is sand and dust on the pole, clean it up and down with a woven bag dipped in water. 2. There is sand and dust on the nylon wheel. To remove the upright pole, use hydraulic pressure to punch out two sleeves and wash them with high-pressure water.
Types of plastering machines
The plastering machine spreads the board wide, with vibration at the back. It can apply 3 centimeters at once without falling off the wall, without hollowing. The machine automatically rises and changes the angle of the plastering board when it is 50 centimeters away from the top. When it reaches the top completely (without leaving a millimeter), it automatically presses down and stops automatically. When the plastering board encounters an obstacle, it will automatically retract, and when it passes the obstacle, it will automatically plug in. The machine automatically stops when encountering obstacles to protect the steel wire rope from being tangled or cut by the winch. After removing the obstacles, it can be automatically or manually lowered. Hand controlled conveyor belts can achieve plastering up and down windows or above doorways. Vertical and flat positioning only takes about ten seconds. Pulling and inserting the upright pole is a simple method, but it is a fast method. The machine is designed according to the entrance of the construction site and can freely enter and exit any room other than the bathroom. Five people (two big workers, three small workers) can spread 450-500 square meters in ten hours (working for ten hours on the construction site), and the benefits are quite considerable..






























