Rubber tensile testing machines may encounter some malfunctions during use. Therefore, today's article compiles some practical troubleshooting methods for common issues that customers frequently face. This way, when the tensile testing machine malfunctions in everyday use, you can attempt to resolve the issue yourself.

Fault 1: The tensile testing machine for rubber products can reset the force value, but there is no response to the force value during testing.

The cause of the issue is: 1. The sensor for the testing space of the dual-space sensor tester was not plugged into the control board, 2. The calibration values were altered.

The solution is as follows: 1. Verify that all sensors on the testing machine are properly connected, 2. Check if the calibration values are correct.

Fault Two: After the rubber product tensile testing machine's computer system is turned on, the machine is unable to access the "Material Testing System"?

Solution:

Please confirm if the computer is still running other applications?

Please ensure the tensile machine software is properly connected to the cables.

Please close other applications.

Issue 3: Pointer does not return to zero during the replacement of the pendulum on the rubber product tensile testing machine.

1. The tensile testing machine is not level: Adjust the machine to be level using a level.

2. pendulum not perpendicular: hang only A weight. Adjust the balancing weight to achieve perpendicularity.

Fault 4: Inconsistent power voltage in the rubber products tensile testing machine.

Solution: Check if there are any blinking lights on the tensile machine control panel for power information, or directly measure the voltage at each output point of the switching power supply. If these methods do not effectively resolve the issue, please notify the manufacturer for repair.

Fault Five: After connecting the rubber products tensile testing machine computer software, a pop-up message displays overload.

The solution is to check if the communication line between the computer and the testing machine has come loose; verify that the correct online selection sensor has been chosen; and inspect the most recent test or operation key.

Has the timing sensor been bumped; check if the software's calibration or calibration feature was used before the issue; verify if any calibration values, calibration values, or other information in the hardware parameters were manually altered.

Tension tester for rubber products showing positive deviation. 1. Loose short arm blade: Tighten the blade securely. 2. Too light pendulum weight: Add weight to the pendulum (considering the weight of A, B, and C weights).

Fault 6: Irregular deviations in the reading of the rubber product tensile testing machine.

1. Oil stains, wear, or burrs on ratchet and gear: Clean the oil stains and burrs from the ratchet and gear, identify the contact points of the ratchet where the excess is occurring, and then correct the ratchet and gear; if the error cannot be eliminated, replace the ratchet and gear.

2. Tensile testing machine not installed level: Adjust for level.

3. Ratchet Bent: Straighten or replace the ratchet, adjust the gap of the rolling groove wheel.