The installation of aluminum craft doors requires careful attention to several aspects: preparation for installation, on-site construction steps, hardware installation, and final touches before acceptance.

Before installing aluminum art doors, it's necessary to prepare tools such as an electric hammer, socket set, pliers, electric drill, rivets, impellers, saw blades, angle grinders, and other hardware tools and materials. Ensure proper matching to avoid multiple empty runs back and forth. It's recommended to organize the tool box before installation, having all necessary or potentially needed tools ready. Preparation is crucial, so let's emphasize that.

During the on-site measurement of the hole, it is necessary to measure the width of the hole for the purpose of determining its dimensions. If breaking through the wall is required, start from this step. Once the hole is measured, you will know the installation location of the aluminum art door. Begin marking the installation location, typically at a stone column, using a level. Drilling requires time and effort. It is recommended to use a water-filled stone drill bit, and spray the drill bit position with a mineral water bottle. When the hole is about two-thirds complete, use an electric hammer to reach the appropriate depth. Secure the posts with expansion screws and start hanging the door on the hinges. After the left fan is installed, the right fan should be installed symmetrically to the left. Repeat the above steps and perform alignment after the door is securely in place.

2. The alignment of aluminum art doors is a crucial step, including corrections for cracks, upright doors, and front-to-back misalignments. During alignment, loosen the expansion bolts until the gate is in a reasonable position, then tighten the bolts and install the lock. At this point, an earth grounding socket should also be made. After the sealant dries, use a wallpaper scraper to remove excess sealant and fill the gaps in the door with sealant. This essentially completes the installation of the main door.

3. Aluminum craft doors come with hardware accessories upon installation, such as locks, grounding plugs, and door openers. When installing the lock, pay attention to whether the lock cylinder and handle are symmetrical and if the handle can switch into place. When installing the door opener, begin by wiring. Typically, the manufacturer of the door opener wires will pre-leave the wire, then lead out the wire to secure the door opener and connect the contacts. After installation, test the door's opening and closing by applying power. This adjustment can be achieved through the door opener control box.

To leave a positive impression, following the completion of the pre-inspection tasks, clean up the site tools, materials, and markings. Secure the screws under the inspection, ensure the overall height consistency of the aluminum art doors, touch up scratches with paint, and clear away the site waste.