How to inspect a plastic pipe production line for defective products?

During the operation of the plastic pipe production line, if there are production defects, production should be immediately halted and the machine maintained. First, reduce the process temperature; generally, during the cooling process of plastic pipe production, it is common to use...At 40 degrees Celsius, but if there are product defects, the water temperature should be reduced to 20-25 degrees Celsius, and simultaneously inspect the machine's water passages for blockages.

If a significant increase in heat is detected during the inspection of the plastic tube production line, along with damaged heating coils, immediate maintenance or replacement is required. Use the corresponding detection equipment to check the inflow rate of the diameter sleeve. If quality issues are found, they should be attributed to the supplier. Please call them immediately to send someone to perform on-site repairs. If all the aforementioned faults are resolved and the products are still defective under certain conditions, inspect the molds to see if they are worn and perform some cleaning.

If using the plastic pipe production line to produceDuring the process of PE pipe manufacturing, there are certain grooves on the appearance, indicating that there must be debris or burrs on the cutting machine or diameter sleeve, which should be cleaned. It is very likely that the residual materials inside the machine were not cleaned after the last production, and the maintenance level of the machine largely determines the precision of the next production. If the internal vibration of the pipe is still present, it is necessary to carefully observe whether the material discharge process is uneven. This could be a fault with the traction machine. Therefore, production workers should be aware of these common malfunctions and maintenance methods when operating the production line machinery.