YOX450 Hydraulic Coupling _ Limited Torque Hydraulic Coupling _ Hydraulic Coupling for Scraper _ Factory Price

Product Introduction

A hydraulic coupler is a mechanical device that transmits rotational speed using a liquid medium. Its driving input shaft is connected to the original driving machine, while the driven output shaft is connected to the load shaft. By adjusting the pressure of the liquid medium, the speed of the output shaft can be changed. In an ideal state, as the pressure approaches infinity, the output speed equals the input speed, similar to a rigid coupling. As the pressure decreases, the output speed also decreases. Continuously changing the medium pressure allows for a stepless adjustment of the output speed below the input speed. The principle of power control and speed regulation, as well as the efficiency, of the hydraulic coupler are based on its aforementioned characteristics. The hydraulic coupler is a type of energy-consuming mechanical speed regulation device. The deeper the speed regulation (the lower the speed), the greater the loss, especially for constant torque loads. Since the original driving input power remains constant, the loss power increases proportionally with the speed loss. For loads like fans and pumps, where the load torque varies with the square of the speed, the original driving input power decreases with the square of the speed, resulting in relatively smaller loss power. However, the output power decreases with the cube of the speed, so the speed regulation efficiency is still very low. The speed regulation efficiency curve of the hydraulic coupler shows an average efficiency of around 50%. A non-rigid coupling that uses a liquid as the working medium, also known as a hydraulic coupling.

Product Actual Photo

Product Features

The impeller and turbine of a hydraulic coupling form a sealed working chamber that allows for the circulation of fluid. The impeller is mounted on the input shaft, while the turbine is mounted on the output shaft. As the power source (such as an internal combustion engine or electric motor) rotates the input shaft, the fluid is ejected by the centrifugal impeller. This high-speed fluid, upon entering the turbine, drives it to rotate, transferring the energy obtained from the impeller to the output shaft. The fluid then returns to the impeller, creating a continuous cycle. The hydraulic coupling transmits torque by changing the momentum of the fluid interacting with the blades of the impeller and turbine. Its output torque is equal to the input torque minus the frictional torque, hence it is always less than the input torque. The input and output shafts of the hydraulic coupling are connected by the fluid, with no rigid connections between the working components. The hydraulic coupling's features include: the ability to eliminate shocks and vibrations; output speed lower than input speed, with the speed difference between the two shafts increasing with load; good overload protection and starting performance, allowing the input shaft to continue rotating even when the load is too high to prevent damage to the power source; and when the load decreases, the output shaft speed increases until it approaches the input shaft speed. The transmission efficiency of the hydraulic coupling is equal to the ratio of the output shaft speed multiplied by the output torque (output power) to the input shaft speed multiplied by the input torque (input power). Generally, a hydraulic coupling can achieve higher efficiency when the normal operating speed ratio is above 0.95. The characteristics of the hydraulic coupling vary due to the shape of the working chamber and the impeller and turbine. If the oil in the hydraulic coupling is drained, the coupling is disengaged, serving as a clutch.