Zibo Hydraulic Coupling Manufacturer Direct Sale - YOXIIZ650 Large Motor Coupling Coupling

Product Introduction

A hydraulic coupler is a mechanical device that transmits rotational speed using a liquid medium. It connects the driving input shaft to the original drive, and the driven output shaft to the load shaft. By adjusting the pressure of the liquid medium, the rotational speed of the output shaft can be changed. In an ideal state, as the pressure approaches infinity, the output speed equals the input speed, similar to a rigid coupling. As the pressure decreases, the output speed correspondingly reduces. Continuously changing the medium pressure allows for a stepless adjustment of the output speed below the input speed. The principle of power control and speed regulation, as well as the efficiency of the hydraulic coupler, are based on the aforementioned characteristics. The hydraulic coupler is a power-consuming mechanical speed regulation device; the deeper the speed regulation (the lower the speed), the greater the loss, especially for constant torque loads. Since the original drive input power remains constant, the loss power increases proportionally with the speed loss. For loads like fans and pumps, where the load torque varies with the square of the speed, the original drive input power decreases with the square of the speed, resulting in relatively lower loss power. However, the output power decreases with the cube of the speed, and the speed regulation efficiency remains low. The speed regulation efficiency curve of the hydraulic coupler shows an average efficiency of around 50%. A non-rigid coupling that uses liquid as the working medium, also known as a hydraulic coupling.

Product Photo

Product Features

The pump wheel and turbine of a hydraulic coupling form a sealed working chamber that allows for the cyclic circulation of fluid. The pump wheel is mounted on the input shaft, while the turbine is mounted on the output shaft. As the power unit (such as an internal combustion engine or electric motor) rotates the input shaft, the fluid is ejected by the centrifugal pump wheel. This high-speed fluid enters the turbine, causing it to rotate and transferring the energy obtained from the pump wheel to the output shaft. The fluid then returns to the pump wheel, creating a continuous cycle. The hydraulic coupling transmits torque by the change in momentum caused by the interaction between the fluid and the blades of the pump wheel and turbine. Its output torque is equal to the input torque minus the friction torque, hence its output torque is always less than the input torque. The input and output shafts of the hydraulic coupling are connected by the fluid, and there is no rigid connection between the working components. The characteristics of the hydraulic coupling include: it can eliminate shocks and vibrations; the output speed is lower than the input speed, and the speed difference between the two shafts increases with the load; it has good overload protection and starting performance, allowing the input shaft to continue rotating even when the load is too great to prevent damage to the power unit; as the load decreases, the output shaft speed increases until it approaches the input shaft speed. The transmission efficiency of the hydraulic coupling is the ratio of the output shaft speed multiplied by the output torque (output power) to the input shaft speed multiplied by the input torque (input power). Generally, a hydraulic coupling can achieve higher efficiency when the speed ratio under normal operating conditions is above 0.95. The characteristics of the hydraulic coupling vary due to differences in the shape of the working chamber and the pump wheel and turbine. If the fluid in the hydraulic coupling is drained, the coupling is disengaged, acting as a clutch.