YOX450 Hydraulic Coupling _ Torque Limiting Hydraulic Coupling _ Special Hydraulic Coupling for Scraper Conveyors In Stock

Product Introduction

A hydraulic coupler is a mechanical device that transmits rotational speed using a liquid medium. Its driven input shaft is connected to the original drive, and the driven output shaft is connected to the load shaft. By adjusting the pressure of the liquid medium, the rotational speed of the output shaft can be changed. In an ideal state, as the pressure approaches infinity, the output speed equals the input speed, similar to a rigid coupling. As the pressure decreases, the output speed accordingly decreases. Continuously changing the medium pressure allows for a stepless adjustment of the output speed below the input speed. The principle of power control and speed regulation for a hydraulic coupler, along with its efficiency, is based on the aforementioned characteristics. A hydraulic coupler is a type of mechanical speed control device that consumes energy; the deeper the speed regulation (the lower the speed), the greater the loss, especially for constant torque loads. Since the original drive input power remains unchanged, the loss power increases proportionally with the speed loss. For loads like fans and pumps, where the load torque varies with the square of the speed, the original drive input power decreases at a rate proportional to the square of the speed, resulting in relatively less loss power. However, the output power decreases at a cubic rate of the speed, and the speed regulation efficiency remains low. The speed regulation efficiency curve of a hydraulic coupler shows an average efficiency of around 50%. A non-rigid coupling that uses a liquid as the working medium, also known as a hydraulic coupling.

Product Actual Photos

Product Features

The impeller and turbine of a hydraulic coupling form a sealed working chamber that allows for the circulation of fluid. The impeller is mounted on the input shaft, while the turbine is mounted on the output shaft. As the power source (internal combustion engine, electric motor, etc.) rotates the input shaft, the fluid is ejected by the centrifugal impeller. This high-speed fluid enters the turbine, causing it to rotate and transferring the energy obtained from the impeller to the output shaft. The fluid then returns to the impeller, creating a continuous cycle. The hydraulic coupling transmits torque by changing the momentum moment through the interaction of the fluid with the blades of the impeller and turbine. Its output torque is equal to the input torque minus the friction torque, thus its output torque is always less than the input torque. The input and output shafts of the hydraulic coupling are connected by the fluid, with no rigid connections between the working components. The characteristics of the hydraulic coupling include: the ability to eliminate shock and vibration; an output speed lower than the input speed, with the speed difference between the two shafts increasing with the load; good overload protection and starting performance, allowing the input shaft to continue rotating even when the load is too great and the shaft stops, preventing damage to the power source; and when the load decreases, the output shaft speed increases until it approaches the input shaft speed. The transmission efficiency of the hydraulic coupling is equal to the ratio of the product of the output shaft speed and output torque (output power) to the product of the input shaft speed and input torque (input power). Generally, a hydraulic coupling can achieve higher efficiency when the normal operating speed ratio is above 0.95. The characteristics of the hydraulic coupling vary due to the different shapes of the working chamber and the impeller and turbine. If the oil in the hydraulic coupling is drained, the coupling is disengaged, serving as a clutch.