Reamer and chamfer measuring instrument

Internal conical gauge measures the maximum diameter of a conical hole or the conical keyway.

One IKT can replace the previous slower and more expensive measurement methods.

Features:

Measure surface and hardened steel cone

Proportional Scaling Indicator: 0.01 millimeter

Calibrate at the factory or through a main station setup

Provide special design as required

Inner Tapered Hole End Face Diameter Measurement System (IKT)

Direct measurement of large diameters for internal cones or conical grooves

Model 60°, 90°, and 127° conical shapes

Application Range: Diameter 0.5mm to 120mm

Measurement Range: 11.5mm, 60° taper/19.5mm, 90° and 127° tapers

Low-Cost Alternative: Internal Conical Gauge IKT - OS

IKT can be used for accurate and quick measurement of the inner cone end face diameter.

Especially suitable for countersunk screw holes, various central holes, tapered holes, chamfering of various grooves, belt wheel frames, etc.

The indicator table provided is a function table, allowing for direct reading of values.

DIATEST can also develop various special-purpose measuring tools according to customer requirements.