Radiation shielding lead doors are a type of important radiation protection product. In recent years, with the continuous improvement in production and living standards, the understanding of health has become deeper. Adding to the fierce social competition, there are more and more severe radiation rays, making radiation protection products an urgent necessity. Standard and requirements for installing lead doors: - Place the guard post into the door opening (remove the guard post panel if necessary), ensuring the edge contact surface is in line with the wall and perpendicular. Correct the simple surface of the wall if necessary. - Inspect the medical protective door to be installed, checking its smooth and unobstructed opening and closing. - Secure the hinge side frame, using explosion bolts (M10, ∮ drill bit) or clips for positioning, ensuring it is sturdy. - Position the hinge side frame perpendicular to the wall, making sure the point and surface are on the same simple plane. - Open the medical protective door and check for smooth operation. - Adjust the lock position width and perpendicular position of the door leaf, ensuring the gap between the door leaf and the door frame is even and consistent, and secure it. - The door body of the protective lead door is made with national standard steel lattices, a stainless steel panel, and sandwiched with radiation protection lead plates, manufactured using advanced cold high-pressure adhesive technology. - After the cement slurry or foam adhesive has dried, remove the gap plate and pads.

Above are the relevant matters regarding lead doors, hoping they are helpful to you.