Through the use of programmableCoil Winding MachineThe controller checks the interface signals of the machine tool control system and compares them with the accurate signals in the interface manual, thereby identifying the corresponding fault points. With the use of the roll bending machine programmer, one can retrieve the intermittent stack and block stack during the system's downtime, and trace the fault to its source based on the indicated reasons.

Additionally, there are some simple manipulation methods that can be used to perform PLG intermittent state analysis with a controller: When a programmable logic controller malfunctions, the cause of the interruption is memorized in the form of an intermittent stack. In cases where a rolling mill system fails to return to the reference point, the oscilloscope of the excavator can be used to check for zero marker pulses. If none are present, it may be considered that the measurement system is damaged.Bending MachineHow can we reduce the occurrence of malfunctions? It's something many people would be excited to see a machine do, so how can we achieve this?

For too many users of bending machines, they have been troubled by some minor issues all along. During this process, how to conduct inspections and adjustments, which are often a headache, is a common concern. Many customers who use bending machines are not very familiar with these common issues. In this situation, how to carry out inspections and propose solutions should be brought up as early as possible. Today, we are sharing this aspect with all our bending machine friends!

For bending machines, when a system malfunctions, it's easy to identify the problem with conventional electrical testing tools. Generally, these minor issues are quite simple to resolve, as long as the specific circuit problem is pinpointed. However, there are times when the bending machine may not present all minor issues in a manner that can be immediately detected by instruments. Other problems might also arise. In such cases, what kind of solutions should we implement?

For Panbo users, here's a share: During a fault exclusion, the system issued an alarm indicating a hardware failure in the bending machine position loop. Inspection with the roller bending machine oscilloscope revealed interference signals, which were filtered out using capacitors at the circuit top, allowing the roller bending machine system to operate normally. This is a commonly used, effective, and quick method for repairing programmable controllers.

For minor issues, our advice to our wide range of bending machine friends is to tackle them yourself whenever possible. Often, if some inappropriate problems arise, the manufacturer can quickly resolve them. In such cases, the cost can be quite high!