Roots blower muffler

Rotary Blower Muffler Application

This series of Roots blower mufflers is designed to reduce the intake and exhaust noise of Roots blowers or Yates blowers.

Features of the Roots Blower Muffler

Simple structure, lightweight, low material consumption, aesthetically pleasing, easy to install, fire-resistant.

Under the same air flow conditions as wind turbines, this series of silencers is also suitable for the exhaust and intake noise reduction of general high-pressure machines.

Roots blower silencer performance

The product offers excellent noise reduction, with a sound absorption value over 25dB(A) and a pressure loss less than 20mmH2O.

Roths Blower Muffler Description

The gas dust concentration through the Roots blower muffler should not exceed 150 mg/m³. If it does, an air filtration or dust removal device should be installed before the muffler. When used outdoors, the muffler should be equipped with a rainproof cover.

The Rothaz fan muffler does not permit the flow of water mist, oil mist, or corrosive gases through the channels. The gas pressure should not exceed 500mmH2O, and the gas temperature should not be higher than 200OC. For special requirements, a custom design can be provided upon the user's submission of specific parameters.

When installing and using various specifications of Roots blower mufflers, it is advisable to set up necessary sound-absorbing and sound-insulating measures on the building of the machine room, depending on the specific situation, to achieve a better noise reduction effect.

This Roce风机 silencer is exclusively designed for installation on air conveying pipelines. If there are special requirements for the gas application, please note them in advance to allow for the use of special protective materials.

Roto-Blower Muffler Overview

Roots blower silencers are mainly used to reduce the intake and exhaust noise of Roots and axial flow fans, and can also be applied for noise reduction of exhaust ducts and other high-pressure fans. They achieve a noise reduction of 15-30 dB(A) with less than 500 Pa pressure loss.

Roots blower silencers are mainly used to reduce the noise of axial flow fans. They are typically circular in structure and come in single-chamber and double-chamber designs. The ZFD single-chamber model has a noise reduction of 15-20dB(A), while the ZFS double-chamber model offers 20-25dB(A). The cross-sectional dimensions are all made according to the national standard for ductwork manufacturing. The micro-perforated plates are made of stainless steel or aluminum alloy.

Section 2: specifications and model numbers of fan mufflers

If the interface exceeds 1600, please contact us, and we will design one for you accordingly.

Section 2: Airflow Muffler Specifications and Models

Interfacing over 1600? Please contact us, as we will design a custom solution for you.

Primarily used for various series of high-pressure centrifugal blowers to reduce aerodynamic noise at intake and exhaust air outlets.

The FG type has flange connections on both ends, allowing it to be串联 in pipelines. The other end features a rainproof cap, suitable only for outdoor pipeline ends and enclosed room intake vents.

The FG type centrifugal fan silencer is developed based on the sound-absorbing principle of sound-deadening panels. This type of silencer boasts excellent acoustic performance and good aerodynamic properties; its structure is rational, easy to install, and is a high-airflow resistive honeycomb silencer. The reactive section employs multi-chamber reactive straight pipe channels and cruciform sound-absorbing panels, ensuring sufficient sound absorption over a wide frequency range. The FT type silencer structure is composed of many parallel unit silencer tubes, filled with porous sound-absorbing material between the tubes. To reduce radiation noise caused by the air flow exciting shell wall vibration, reinforcing ribs are set on the outer shell.