What do triangle tube manufacturers use for?

Which is better, a triangular beam made of angle steel焊接 and a truss made of round tubes?
To assess the cost of the materials used, specifically, to calculate the cost of each material individually to determine which one is more cost-effective.
2. The processing technology should be tailored to the technical strengths of our factory workers. What may be a processing challenge in one factory could be a piece of cake in another.
3. Determine which materials are suitable for the processing equipment at our facility.

Casing-type Pillar

The tube is inserted into the riser, adjusting the height by the spacing of the bore holes. The top "U" bracket of the tube supports the crossbar for laying the scaffold plank, as shown in Figure 3-5. The height of the construction is generally 1.57 to 2.17 meters.

Insert-Fit Steel Pipe支柱

Established at heights of 1.2m, 1.6m, and 1.9m, a pin must be added during the third step of the bracket assembly for safety purposes. See Figure 3-6.

Section Three: Collapsible Tripod with Umbrella Base

It consists of a column (umbrella-type支柱), casing, beam or truss. The lower end of the column features feet resembling ribs, which can be expanded or retracted. There is an axis hole in the column, allowing the casing to rise and fall within it to adjust the casing height; see Figure 3-7. This type of inner scaffolding can be set up with either a single row or double row of columns, as needed. For a single row setup, one end of the beam (the end with the welded angle steel) is placed against a brick wall, while the other end is inserted into a pipe within the casing; for a double row setup, a truss is used as the beam.

The spacing for the canopy支柱 installation is 2 meters for masonry work and 2.5 meters for painting.