To resist accidental accidents from external equipment of industrial buildings and maintain the integrity of internal equipment within industrial buildings, doors can prevent the occurrence of other situations. What are the installation requirements and maintenance methods for doors? Below, the editor from the door manufacturer will introduce them to you.
Door Installation Requirements:
Upon installation, follow the specified method to ensure the door is installed vertically and flat, with smooth operation. After closing the door, place the stopper on the fixed brackets on both sides of the door frame, and then bury the door 10 centimeters deep with sand or soil beneath the outer door.
2. Installation Method for Doors:
First, measure and organize the width and height of the tunnel entrance, ensuring the door (including the embedded parts) fits in entirely.
(2) Lay two doors flat on the ground, arrange the sealing rubber sheet between the two doors, and secure them with bolts for installation.
(3) Adjust the orientation so that the door can only open outward, then simultaneously lift both doors with force to stand them upright at the well opening.
(4) After adjusting, secure the entire door with wooden props.
(5) Begin砌墙固定，as per wellhead design.
After the wall sets, close the door and place the stopper on the fixed brackets on both sides of the door frame. Then, bury the bottom of the outer door with sand or soil to a depth of 10 centimeters, and it can be used normally.
3. Door Maintenance Methods:
(1) Any areas where the rust-proofing material has peeled off or been knocked off should be repainted.
(2) If the sealing rubber strips are damaged or delaminated, they should be replaced or bonded promptly.
(3) If there is rust on the hinge parts of the door, they should be cleaned and wiped, and then re-oiled.
About the installation requirements and maintenance methods for doors, we have covered that for you. If you would like to learn more...DoorFor other common knowledge, please consult and learn more on our website.
