How to install electric roller shades is a commonly asked question. There are various types of electric roller shades, and the installation methods differ depending on whether they are mounted on facades or at different top locations, so we will describe them separately.

Electric sunshading curtains are automated curtains designed for sun protection, typically made of fabric materials. They are generally categorized into two types based on their installation—either on the facade or the ceiling. The electric sunshading curtains on facades are usually roller shutters, while those installed on ceilings are typically canopy shades.

Installation Methods for Electric Roll Shutters

Electromagnetic Roll Shutter

The linear guide and the bottom guide are connected using angle and countersunk self-tapping screws.

Insert the end cap into the track.

3. Secure the track to the wall.

4. Assemble the roll (including the curtain blades and accessories, roller tube, motor, and related components) by securing it with a rope to tightly wrap the curtain blades around the roller tube, and then insert it into the end plates.

Step 5: Install the guide block (This step can also be completed in Steps 1-3. Skip this step if the guide block is not provided.)

6. Power on the unit and adjust the limiters and fix the movable tray bracket.

7. Fixed housing, front guard (or front clip).

8. Put on the protective helmet and face mask.

Different types of electric roller blinds have varying installation methods. Below is a general overview of the installation process for reference.

Electrified Skylight Blind Application Effect Image

Select track length based on window size and provide outlets and switches.

2. The track is connected using hollow screws, and the three-core wire is threaded through the center of the track. After the track is properly connected, the wire emerges from both ends, with the interface being concentric and flat, allowing the motor to pass through smoothly.

3. Place a support rod over the track, with one elastic rubber ring on each side. Fit an electric motor at each end, with the motor wires facing outwards. Place several curtain rings behind the motors (6 per meter).

4. Install the bracket using a涨塞on the wall or ceiling, then assemble the track, motor, and bracket rod onto the bracket, and tighten the bracket rod with the top screw.

Connect the center line and motor wire by color. One end is inserted into the control box and connected with the capacitor, power supply, and switch.