Condensers should be cleaned regularly to maintain cleanliness. Dehumidifiers should be placed in the central position of the room. Ensure that there are no obstructions blocking the air inlets and outlets of the dehumidifier, and the air filter should be cleaned thoroughly. Water droplets on the evaporator surface will freeze if the surrounding temperature is below 15℃, reducing the dehumidifier's effectiveness. If the surrounding temperature exceeds 40℃ or more, the system pressure will increase, leading to compressor overload. In this case, the overload protector should disconnect the circuit; otherwise, the compressor motor may be damaged. Therefore, the dehumidifier should be used within a temperature range of 15℃ to 40℃. Air humidity below 30% can be too dry and uncomfortable, so it is advisable to use a humidity controller to maintain a range of 50% to 60%. Close doors and windows as much as possible when in use to achieve the dehumidifying effect. Place the unit flatly, avoiding tilting or lying down to prevent malfunctions or abnormal noises.

If the dehumidifier's water tank is overfilled, to prevent overflow and wetting the floor, please unplug the power cord before moving the unit while it's running. After moving the dehumidifier, allow it to sit idle for four to six hours before turning it on again. This is because the compressor lines in the dehumidifier contain refrigerant, which needs four to six hours to settle after moving. Clean the air filter regularly (about once every two weeks) to maintain the dehumidifier's efficiency and longevity in removing moisture and dust. You can wash the air filter with clean water below 40°C; using a detergent is even better. After removing the dust, rinse it thoroughly and let it air dry before reinstalling it inside the unit.

When cleaning the body, gently wipe with a damp cloth; avoid pouring water directly to prevent damaging the electrical insulation. For sticky substances on the surface, use soap and water for cleaning; avoid using gasoline, kerosene, or solvents to prevent paint peeling or discoloration. Do not use a thin stick or wire to probe inside the machine to avoid malfunctions or hazards. When experiencing a power outage, or if the machine will not be used for a long time or during travel, please unplug the power cord to maintain the machine's lifespan.