Olympus ultrasonic probe for measuring shear wave velocity, Young's modulus, and shear modulus

Vertical incidence shear wave probe

Single crystal vertical incidence shear wave contact probe can directly transmit shear waves into the workpiece being measured without the need for refraction mode conversion of ultrasonic waves.

We recommend using our SWC shear wave couplant for general-purpose testing.

Advantages and Features:

• Generate transverse waves that propagate perpendicular to the surface being measured.

• For ease of alignment, the transverse wave polarization is nominally aligned with the right-angle connector.

• The ratio of longitudinal to transverse wave components is generally less than -30 dB.

Application:

• Transverse wave speed measurement

• Young's Modulus and Shear Modulus Calculation

• Characterization of material grain structure

Direct Contact Series

• WC-5 Abrasion Plate enhances the probe's durability and wear resistance

• Offer standard and finger-type shell styles

• 304 Stainless Steel Shell

We offer the following frequencies and chip sizes for selection.

• Frequency: 0.1MHz, 0.25MHz, 0.5MHz, 1MHz, 2.25MHz, 5MHz

• Chip Sizes: 3mm, 6mm, 13mm, 25mm

Delay Block Series

• Integrated delay blocks enable measurements at higher frequencies.

• Fused quartz delay blocks significantly reduce attenuation and provide physical protection for wafers.

Transverse Wave Coupling Agent SWC

Vertical incident transverse wave, non-toxic, highly viscous, water-soluble organic substance