Rapid roll-up doors are a type of quick-lifting partition door, which can be found in the chemical industry, supermarkets, electronic factories, and logistics warehousing sectors.

The appearance of rapid roller shutters is generally achieved through high-strength cold-rolled steel plate spray-painted molding, making the debugging and acceptance after installation particularly important.

Rapid roller shutter safety base acceptance test as follows:

1. First, deactivate the emergency stop button on the rapid roller shutter, turn on the power to the electric control box of the rapid roller shutter, press the learning button on the bottom edge receiver panel once, and check that the signal receiver light is illuminated.

2. Press the safety bottom edge loop of the rapid door a few times; the signal indicator light blinks to indicate successful reception. Repeat pressing the bottom edge pressure tube; each press lights up the receiver light to test that the signal connection is complete.

3. Activate the emergency stop button on the electric control box of the rapid roller shutter door, press the pressure hose inside the bottom fabric pocket, and the door body of the rapid roller shutter door will automatically rise upon receiving the signal, operating normally.

4. During the testing of the rapid roller shutter safety bottom and the use of the rapid door, if the electrical control box fails to receive the safety bottom signal, it is necessary to check the battery and the pressure hose of the safety bottom transmitter. If the battery is depleted, replace it with a new one.

If the bottom pressure hose is damaged or leaking, the damaged or leaking section must be sealed, and a new safety bottom pressure hose may need to be replaced if necessary.