I. Product Features
The JD-9359RTV series produced by Jiudian Industry Co., Ltd. is a single-component room temperature curing silicone adhesive and sealant, with the cured adhesive layer forming an elastomer.
The following features are available:
Neutral-temperature curing, capable of bonding and sealing the vast majority of metals without corrosion.
2. With resistance to cold and heat alternation, capable of operating within a wide temperature range (-60～250℃), featuring excellent tensile, vibration, and shock resistance; and possessing weather resistance, heat resistance, cold resistance, hydrophobicity, and resistance to acidity and alkalinity.
3. The adhesive layer features moisture-proof, fixing, shock-resistant, covering, corona-resistant, and anti-leakage properties.
Typical Applications
Widely used in electronic and electrical components, modules, electrical appliances, microwave ovens, metals, plastics, and mechanical engineering adhesives and seals.
2. Bonding: Excellent adhesion to most materials, suitable for elastic bonding agents between silicone and plastic, metal and silicone, and metal and inorganic materials. It is non-corrosive to the bonded materials and serves as a bonding agent between silicones and other materials, such as bonding for TV deflection coils, waterproof and moisture-proof bonding for underwater instruments, elastic bonding for instruments and meters, and bonding of silicone buttons, etc.
3. Coating: Widely used for the coating of various electronic components, semiconductor equipment, and industrial electrical appliances. It serves as insulation, moisture-proof, shockproof, and protective functions.
4. Sealing: As filling material for gaps in electronic components, instrument compartments, ship cabins, etc. Sealing of lamp wiring ends, electrical and electronic wire ends, sealing at the end of an electric rice cooker's heating tube, sealing of chemical equipment, flowmeters, sight glasses, electrical appliances, as well as anti-loosening sealing for screws.
Section 3: Manufacturing Process
1. Clean Surface: Thoroughly clean the surface of the item to be bonded or coated, removing rust, dust, and grease, etc.
2. Gluing: Unscrew (or cut off) the cap of the glue tube, squeeze the glue onto the cleaned surface, ensuring even distribution, then clamp and secure the surfaces to be bonded together.
3. Curing: Place the glued or sealed parts in the air to allow natural curing. The curing process is from the surface to the inside. Within 24 hours (at room temperature and 55% relative humidity), the adhesive will cure to a depth of 2-4mm. If the location is deeper, especially in areas that are not easily exposed to air, the curing time will be extended. If the temperature is lower, the curing time will also be extended. It is recommended that users wait a sufficient amount of time before proceeding with further treatment or packaging the bonded parts to ensure the integrity and strength of the bond are not compromised.
4. Cautionary Notes
After operation, any unused adhesive should be immediately capped and sealed for storage. Upon reuse, if there's a little skin on the seal, just remove it; it won't affect normal use. During storage, a small amount of curing may occur at the tube mouth, which can be cleaned off for normal use without affecting product performance.
V. Technical Parameters Before and After Curing

All mechanical and electrical properties were measured after the material had cured for 5 days at 25°C and 55% relative humidity.
Section 6: Packaging Specifications
310ml per piece, 25 pieces per carton.
Section 7: Storage and Transportation
Shelf life is 12 months (at 25°C).

2. These products are non-hazardous and can be transported as general goods.