Connect the electrical control box to a 220V voltage. If the indicator light does not illuminate, check the fuse position on the outer side of the control box and ensure the fuse is intact.

Connect the electrical control box to a 220-volt supply, adjust the speed control rotary switch, and ensure it rotates in the specified direction. Observe the vibration plate's speed as it gradually increases to exceed 20% more than the required speed. If the voltage is unstable, the vibration plate may exhibit intermittent fluctuations in speed.

Three, when placing parts on the vibration plate for one-time use, the size of the plate can be adjusted according to the diameter. If the parts in the vibration plate do not cover the base plate, add material immediately.

If the speed control rotary switch on the vibration plate is turned all the way and the work still does not move, please immediately shut down and check for any faults with the base plate.

Reasons are three:

Inspect each spring strip for any signs of breakage.

2. Are the bolts loose?

3. Spring tabs require readjustment.

Solution:

Just replace the spring clips.

2. Just tighten the bolt.

Adjust the spring clip.

Note: To adjust the spring plates, select any group of spring plates, slightly loosen the bolt, and observe if there is any change in the vibration plate's speed. If it becomes faster, replace the spring plate with a thinner one; if it becomes slower, replace it with a thicker one. By following this method, the vibration plate can be adjusted to the desired speed.

Automated auxiliary bucket, specially designed to save on raw and auxiliary materials, automatically supplies materials to the vibratory hopper. The amount of discharge can be adjusted by changing the size of the vibration switch.

2. Photoelectric switches automatically stop the vibration pan when the feeding track is full, and restart it when it's empty. An indicator light illuminates to warn of empty or full material conditions, saving electricity and extending the vibration pan's lifespan.

3. Material control switch: automatically feeds the auxiliary material bucket to the vibration disk when it detects a lack of material in the vibration pan.

4. The straight feeding machine can connect the distance between the vibration pan and the machine track, making the material discharge smoother and less prone to jamming.