Radar is a radio device that uses radio waves to determine the location of objects. To avoid interference from surrounding buildings, radar towers are typically as tall as 100 meters.
Approximately m, due to the performance requirements of the radar, the fundamental frequency of the radar tower must not be less than 1.0 Hz. Through extensive calculations and analysis, some findings have been identified that can significantly improve...
Basic frequency patterns of high radar towers. Radar towers are extensively applied in modern times, whether at sea or on land, in transportation, and are used for positioning...
Position, speed measurement, search, etc. Meanwhile, the seismic response of the radar tower was analyzed using the response spectrum method, time-history analysis, and random vibration method. Calculations
The results indicate that the radar tower meets the seismic code requirements for inter-story displacement.
Tower Structure:
The entire steel tower is mainly composed of three major parts: the tower head, the tower body, and the tower legs. For guyed towers, an additional guyed section is included. The tower head extends upwards from the tower legs to the tower frame section.
Sharp change (as indicated by a break line) above the specified section is the tower head. If there is no sharp change in cross-section, then the part above the lower horizontal brace is the tower head. Tower leg
Above the base, the segmental tower is referred to as the tower leg, the part between the tower leg and the tower frame is called the tower body.
Technical Specifications:
1. Basic Wind Pressure: w0 = 0.4 - 0.8 KN/m²
2. Seismic fortification intensity: 8 degrees and below
3. Foundation bearing capacity: 100 and 200 KN/m²
4. Ice Thickness: ≤10mm
5. Verticality: ≤1/1000
6. Corrosion Treatment: Hot-Dip Galvanized
Technical Specifications:
1. Code for Design of Lightning Protection for Buildings (GB50057-94)
2. Tall Structure Design Code (GBJ135-90)
3. Steel Structure Design Code (GB50017-2003)
4. Specification for Construction and Acceptance of Steel Mast Structures (CECS 80:2006)
