When using high-temperature industrial ovens in our daily operations, the drying machines occasionally encounter minor issues. Do you know how to troubleshoot and repair these problems? Additionally, what are the reasons behind these issues with high-temperature industrial ovens?

The large and small gears of the high-temperature industrial oven have been damaged due to the mesh gap: a. Wear on the drag wheel, b. Wear on the stop wheel, c. Wear on the small gear. The solution to eliminate this is to either turn or replace them based on the wear condition. Additionally, we can install them on the reverse side or replace them in pairs.

2. Overall vibration is caused by the damage to the connection between the a tug device and the base. The solution is to realign and tighten the connection to its proper position. b The industrial oven's roller ring side is worn due to high temperature. The solution is to grind or replace the roller ring based on the extent of wear.

3. After drying, the moisture content of the material exceeds the specified value; the solution is to control the production capacity of the high-temperature industrial drying oven in the dryer, by increasing or decreasing the heat supply.

4. The rolling rings exhibit swing during the cylinder's operation, primarily due to the loose fit of the concave joint sides. The solution is to use shims to ensure even and proper alignment of the rolling rings and concave joints, along with the addition of gold plating to prevent over-tightening and potential accidents.