Aerated Pond Flow Divider Manufacturer
QJB7.5/4-2500/2-38/P
Diving Propeller Mixer Model Specifications
Motor Power: 7.5 kW
Impeller Diameter: 2500mm
Impeller Speed: 38 RPM
Diving Propulsion Installer Diagram
Jiangsu Du'an Environmental Protection QJB7.5/4-2500/2-38/P Submersible Propeller's Component MaterialPropeller: Reinforced Polyurethane
Gearbox: Cast Iron DIN1691 GG25 (ASTM A48 35B)
Motor housing: Cast iron DIN1691 GG25 (ASTM A48 35B)
Axle: Stainless Steel
Mechanical Seal: Silicon CarbideSilicon Carbide Fasteners: Stainless Steel AISI 316 Cable Sheath: Chloroprene Rubber
O-ring: Nitrile or Fluororubber; Flow Guide Bracket: Stainless Steel AISI 304
Guideway System: Stainless Steel AISI 304
Enhanced Steel Wire: Stainless Steel AISI 3164
Lifting Device Boom: Stainless Steel AISI304
Chemical Foot Bolts: Stainless Steel
Surface Corrosion Protection: Two-component epoxy resin coating, each primer layer applied in two coats 100μm, face paint thickness: 120μm.
Duwan Environmental's QJB Submersible Flow Generator Controller
The operation of the submersible propellers is via local manual control. Two methods of PLC automatic control.
Manual control
The dive propeller should be equipped with manual control, allowing operation even when automatic control is not achievable.Achieve manual control. That is: when the control panel on the cabinet“Selector switch”Placed in manual control position, the machineManual operation is available on-site through control switches, with handle control buttons for separate operation of the equipment.
2. Automatic Control
Please provide the Chinese content you would like translated into American English. Under PLC automatic operation, the submersible propeller is controlled automatically by time. The submersible mixer operates continuously or intermittently.
When the switch is set to the fully automatic control position, the machine can operate in the following modes.
(1) Through the start button on the control panel. (2) Through the time control on the control panel.
Low-speedDivingStreamingField control box for equipment
Field control box for equipment outfittingMeet all design specifications, while complying with IEC Standard or higher than standard IEC StandardNational Standards; meets local climatic conditions.
Each set of dive thrusters is equipped with a local control box. The specifications for the on-site control box are as follows:
（1) In addition to the internal buttons and signal lights, 35 terminals are included.
（2) Order converters for motor protection and equipment as a matched set.
（3) The start/stop button should have two sets of contacts, and the stop button (with a mushroom head) should remain in the pressed position.
（4) To ensure a seamless connection between the field control box and the entire plant control system, the terminal blocks within the control box are fitted with Weidmüller products.
（5) With cable connectors.
（6) Protection Level: IP65.
（7) Reserve PLC interfaces; each unit requires control from both the local control cabinet and the central control room.
（8）Material of on-site control box: outdoor use 304 Stainless steel, carbon steel coated for indoor use, housingThe color is determined by Blue Deep Group.
（9) Components in the control box are from ABB, Schneider, Siemens, or equivalent brands.
Wooden box packaging
Logistics Transportation
Provide installation and debugging guidance
